Added property to set 4th axis if available for Mach3Mill post.

Added posts for CAMaster with WinCNC control.Added support for setting machine type for Intelitek post.Updated multi-axis support to handle rewinds better for Pocket NC post.Fixed SafeZHeightForWorkpiece for DATRON next post.Add missing G90 for HAAS posts after machine retract.Add missing G90 for 5AXISMAKER post after machine retract.

Add missing G90 after machine retract for DMS Router posts.

Add missing G90 after machine retract for CR Onsrud 5-axis Router post.

Fixed missing output of rotaries issue for posts with subprograms.Fixed issue with memory usage when machining tiny pockets for Adaptive Clearing.Fixed wrong toolpath for circular nested pockets for 2D Pocket.Fixed wrong toolpath for Swarf when using surface driven mode.The following changes were made in an earlier update (2018.2.2): Changes in toolpath generation: Improved stock simulation of simultaneous multi-axis toolpath.Show number of holes being machined for Drill.Show live tool setting for the Drill operation for mill-turn.Fixed issue where the maximum spindle speed would be overwritten when selecting tool which uses constant surface speed.Fixed issue where pasted operations would not be marked as out-of-date when pasting into a different job.Fixed issue when selecting a tool from different operation in the tool library did not use the desired feedrates and speeds.The main cutting direction (normally Climb) will be the preferred cutting direction but the opposite direction will be used when the alternative non-engaging stay down linking would be estimated to be longer. You can use this feature to reduce machining time further when roughing depending on the material you are machining. When both ways is enabled you can set a separate load and feedrate for the opposite cutting direction. Added support for both ways Adaptive Clearing.Added support for back cutting (used for Sandvik PrimeTurning) for Turning Profile.You can use this feature to break the chips. Added support for pecking for Turning Profile.The following changes have been made in the current update (2018.3): This release contains a number of important fixes and improvements, as identified below. HSMWorks Ultimate (formerly HSMWorks Premium).HSMWorks Premium (formerly HSMWorks Professional).This document covers all three HSMWorks products:

HSM 2017 with solidworks 2018